Owners have filed 328 complaints about the 2003 Hyundai Tiburon with NHTSA, more than any other Tiburon model year on record.
Most reports involve the transmission and drivetrain: 164 complaints, or 50% of everything filed, followed by air bags (71) and electrical system (34). Half of those transmission reports describe a failure before 31,000 miles.
Complaints for this year mention 33 crashes, 7 fires, 21 injuries, and 1 death. These are owner reports and have not been verified by NHTSA.
NHTSA lists 9 recalls for this model year. The most recent, campaign 09V125000, was filed in April 2009 and concerns the control arm.
EPA figures put it at up to 23 MPG combined (20 city, 27 highway) in its most efficient version, out of 6 configurations tested, close to the average subcompact car of its year.
09V125000
Filed Apr 16, 2009 160,904 vehicles
Hyundai is recalling 160,904 my 2001-2003 elantra and my 2003 tiburon vehicles originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia. Road salt used during the winter months in these jurisdictions may result in internal corrosion and thinning of the steel in the front lower control arms. The corrosion may progress to the point where the lower control arm's upper and lower panels become perforated. A perforated front lower control arm may fracture between its ball joint attachment and the forward and rearward pivot attachments to the chassis.
Risk and remedy
- Risk
- The fracturing of the control arm could an owner's control over their vehicle that may increase the risk of a crash.
- Remedy
- Dealers will inspect the front lower control arms for corrosion damage. If specified levels of internal corrosion damage are found, the front lower control arms will be replaced with new front lower control arms incorporating additional holes in the upper and lower panels. If the front lower control arms do not require replacement, the dealer will add drainage holes to the front lower control arms and will treat the front lower control arms with rust-proofing materials to arrest the internal corrosion process. These procedures will be performed free of charge. The recall began on august 17, 2009. Owners may contact the hyundai customer assistance center AT 1-800-633-5151.
- Filed by
- Hyundai Motor Company (manufacturer number 091)
Certain passenger vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 301, "fuel system integrity" a valve on the fuel tank assembly may not close properly. If a vehicle rolls over and the fuel tank assembly valve is not properly closed, fuel spillage may occur.
Risk and remedy
- Risk
- Fuel spillage in the presence of an ignition source may result in a fire.
- Remedy
- Dealers will install an additional fuel tank assembly valve. The recall began on october 5, 2004. Owners should contact hyundai de puerto rico AT 1-800-981-0188.
- Filed by
- HYUNDAI CARIBBEAN-PUERTO RICO (manufacturer number 066)
Some passenger vehicles contain a fuel tank assembly valve that may not close properly. If a vehicle with a fuel tank assembly valve that is not properly closed were to roll over, fuel spillage may occur.
Risk and remedy
- Risk
- Fuel spillage in the presence of an ignition source may result in a fire.
- Remedy
- Dealers will install an additional fuel tank assembly valve. Owner notification began on june 30, 2004. Owners should contact hyundai AT 1-800-633-5151.
- Filed by
- HYUNDAI MOTOR COMPANY (manufacturer number 066)