Owners of the 1990 Jeep Cherokee have reported 153 brakes problems to NHTSA, 57% of all complaints about this model year.
Where owners named a specific part, the most common were antilock/traction control/electronic limited slip (105), foundation components (48), and power assist (3).
The typical report came at around 137,000 miles, and complaints were filed between January 1995 and October 2022.
These brakes complaints include 9 crashes, 1 fire, and 4 injuries.
For comparison, the 2014 Cherokee has the most brakes complaints of any year, with 211.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
4 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Oct 2022195,492 milesMT
The contact owns a 1990 Jeep Cherokee. The contact stated while driving 30-45 MPH, the brake pedal was depressed but the vehicle failed to respond. The contact stated that he increasingly applied pressure on the brake pedal until the vehicle responded. There was a 100-feet stopping distance delay. The dealer was notified of the failure and declined to diagnose the vehicle. The contact provided a description of the failure to the dealer who informed him that the brake pump motor assembly needed to be replaced; however, the parts were no longer available nationwide. The vehicle was not repaired.
Owner complaint 11491351 filed with NHTSA
BrakesFiled Mar 2020164,000 milesCA
Tl* the contact owns a 1990 Jeep Cherokee. While driving AT an unknown speed, the brake pedal was depressed but failed to stop to stop the vehicle. The parking brake was engaged to stop vehicle. The vehicle was towed to contact's residence. The vehicle was taken to an independent mechanic who stated the vacuum pump motor failed. The contact called crown dodge chrysler Jeep ram located AT (6300 king dr, ventura, ca 93003 (805) 323-3363) but the vehicle was not diagnosed nor repaired. The manufacturer was contacted but offered no assistance. The failure mileage was approximately 164,000.
Owner complaint 11315821 filed with NHTSA
BrakesFiled Mar 2019200,000 milesCA
Tl* the contact owns a 1990 Jeep Cherokee. While the brake pedal was depressed, there was an abnormal noise coming from the front passenger side of the vehicle. The contact mentioned that the vehicle was repaired per NHTSA campaign number: 96v260000 (service brakes, hydraulic) years before the failure. The vehicle was taken to crown dodge chrysler Jeep ram (6300 king dr, ventura, ca 93003) where it was diagnosed that the brake actuator assembly and the pump motor assembly needed to be replaced. The vehicle was not repaired because the manufacturer was no longer making the parts. The manufacturer was notified of the failure.
Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors CAN experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion CAN eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
Risk and remedy
Risk
The reduced strength CAN allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.
Remedy
Dealers will replace these rotors with rotors that are coated with a corrosion protection.
Vehicle description: vehicles equipped with antilock brake system (ABS). The antilock brake system (ABS) hydraulic control unit CAN experience excessive brake actuator piston seal wear which could cause pump-motor deterioration.
Risk and remedy
Risk
If this occurs, the ABS function would be lose and reduced power assist would be experienced during vehicle braking. The instrument panel warning lights will signal system impairment and the base manual brakes will remain functional.
Remedy
Dealers will test the vehicle's ABS and repair as necessary. The warranty on all ABS components will be extended to 10 years or 100,000 miles (except for the brake actuator piston assembly and the pump-motor assembly which will have a lifetime coverage). Owners will be reimbursed for previous ABS component repair costs.
There may be hydraulic fluid contamination from condensation formation that CAN plug the ABS brake booster pump filter; stress corrosion of the master cylinder snap ring has been traced to chlorine leaking from the low pressure hydraulic hose which may cause it to break; front brake hose to tire interference which may cause failure of the brake hose.
Risk and remedy
Risk
Contamination of the hydraulic fluid CAN causemalfunctioning of the anti-lock brake system; low pressure hose leakage causesloss of brake fluid and also results in corrosion and failure of the mastercylinder snap ring, resulting complete brake failure; failure of the front brakehose due to hose to tire interference will cause failure of one half of thebrake system resulting in a longer stopping distance than expected.
Remedy
Replace ABS low pressure hose; rebuild master brake cylinder; inspect, service interference problems, and replace front brake hose as necessary.
Improper insertion/crimping of the hose-to-end fittings of the high pressure hose on the anti-lock brake system CAN cause detachment of the hose from the ABS system, and discharge of hydraulic fluid.
Risk and remedy
Risk
Detachment of the hose from the ABS system causes theloss of the ABS function and hydraulic brake assist, leaving only manual brakesand decreasing stopping ability, which could result in an accident. Discharge ofhydraulic fluid in the area of the hot exhaust system could result in an enginecompartment fire.