Owners of the 1998 Jeep Cherokee have reported 88 brakes problems to NHTSA, 22% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (73), antilock/traction control/electronic limited slip (14), and conventional (2).
The typical report came at around 113,000 miles, and complaints were filed between December 1996 and August 2015.
These brakes complaints include 5 crashes and 6 injuries.
For comparison, the 2014 Cherokee has the most brakes complaints of any year, with 211.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
2 recalls for this model year involve the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled Aug 2015203,714 milesWV
I think my Jeep is remotely bugged somehow, ABS light comes on and my brakes work, ABS light goes out and my brakes make noise and pedal goes down further like I have no brakes. Also, temperature gauge is steady then suddenly it goes up and down. I have checked fluids, had brakes inspected (replaced pads and front rotors) I went to police said they had no way of testing for bugs.
Owner complaint 10759591 filed with NHTSA
BrakesFiled Feb 2014204,600 milesIL
The button and spring popped out of the emergency brake lever upon application of the brake. It appears there might have been many similar incidents and possible NHTSA incident number applied for earlier model years. That number 95rv172000 was obtained via internet search of Jeep owner websites and commercial automotive magazine information. The emergency brake is inoperable without the release button, however, AT this time the brake is in the released position and vehicle is drivable.
Owner complaint 10563899 filed with NHTSA
BrakesFiled Dec 2005112,750 milesCA
The first incident happen around nov of 2002, while driving on a wet road in tampa, fl, speed about 35 MPH. I was attempting to stop AT a stop sign. When I apply my brakes, the rear brakes locked up and I slid through the stop sign, missing two cars. The rear brakes lock up AT odd times. The brakes have been replaced and the housing has been cleaned, both drums have been turned. Fluid has been drained from system and replaced with new dot 3 brake fluid. No improvement, brakes still lock up.
Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors CAN experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion CAN eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
Risk and remedy
Risk
The reduced strength CAN allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.
Remedy
Dealers will replace these rotors with rotors that are coated with a corrosion protection.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 879)