Owners of the 1999 Jeep Cherokee have reported 102 brakes problems to NHTSA, 28% of all complaints about this model year.
Where owners named a specific part, the most common were foundation components (85), antilock/traction control/electronic limited slip (20), and pedals and linkages (2).
The typical report came at around 82,000 miles, and complaints were filed between November 1998 and May 2018.
These brakes complaints include 5 crashes, 1 fire, and 2 injuries.
For comparison, the 2014 Cherokee has the most brakes complaints of any year, with 211.
Service and parking brakes: pedal feel, ABS and traction modules, rotors, calipers, hoses, master cylinders and brake boosters.
1 recall for this model year involves the brakes.
If your problem matches, a dealer repairs it free under the recall.
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
BrakesFiled May 2018223,827 milesMI
Tl* the contact owns a 1999 Jeep Cherokee. While the vehicle was stationary, the brake lines became severely rusted and corroded. The dealer (cueter chrysler Jeep dodge ram in ypsilanti, michigan) was made aware of the failure. The vehicle was not diagnosed or repaired. The manufacturer was made aware of the failure. The failure mileage was 223,827.
Owner complaint 11091961 filed with NHTSA
BrakesFiled Aug 2015179,962 milesLA
I was AT a stop sign, proceeded to accelerate, arriving AT a stop-light when vehicle would not stop, brake pedal was pushed all the way to floor, pedal seemed to have no leverage to it. I coasted to a safe place to pull over, had to use emergency brake to stop. Checked all fluids and pads, those components seemed to be fine. And had to get vehicle towed it was unsafe to drive.
Owner complaint 10748667 filed with NHTSA
BrakesFiled Jan 2015WA
No crash, no accident this is a complaint on safety and lack of availability to a "do it yourself" (diy) certified mechanic on brake bleeding. I AM a certified aviation mechanic and well versed on bleeding brakes. On the Jeep listed there is a requirement to use a scanner (the chrysler drb III scan tool) which plugs into the OBD-2 system to run the pump in the ABS system. This running of the ABS pump should move any air within, into the lines so that subsequent bleeding of the wheel lines will remove the air.
Vehicle description: passenger and multi-purpose vehicles originally sold or currently registered in the states of connecticut, illinois, indiana, maine, maryland, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, or wisconsin, and the district of columbia. The front disc brake rotors CAN experience severe corrosion if operated for an extensive period in the "salt belt." if the rotors are not replaced, the corrosion CAN eventually compromise the structural integrity of the stamped steel center hub section of the rotor.
Risk and remedy
Risk
The reduced strength CAN allow the cast iron wear surface to separate from the hub, reducing the brake effectiveness of the vehicle.
Remedy
Dealers will replace these rotors with rotors that are coated with a corrosion protection.
Filed by
DAIMLERCHRYSLER CORPORATION (manufacturer number 879)