Owners have filed 4 complaints about the 2007 Mercedes-Benz R-Class with NHTSA.
The largest share concerns the electrical system (2 complaints, 50% of the total), followed by seats (1) and brakes (1).
Complaints for this year mention 1 fire. These are owner reports and have not been verified by NHTSA.
NHTSA lists 3 recalls for this model year. The most recent, campaign 08V303000, was filed in July 2008 and concerns the electrical system.
EPA figures put it at up to 21 MPG combined (19 city, 26 highway) in its most efficient version, out of 4 configurations tested, 4 MPG better than the average SUV of 2007.
Mercedes-benz is recalling my 2006-2008 m-class, r-class, my 2005-2009 slk-class, my 2005-2008 c-class, my 2003-2004 and 2006-2008 clk-class, my 2003-2008 e-class, my 2004 and 2008 cl-class, my 2008 cls-class, my 2004 and 2007-2008 s-class, my 2003 g-class, and my 2003-2004, 2006 and 2009 sl-class vehicles. A software calibration number (scn) coding received on the affected vehicles during a recent workshop visit was incorrect. Depending on the model year and model affected, the results of an incorrect scn coding CAN affect a number of vehicle safety and emission functions including the following types of functions: (1) the fuel gauge readings may be incorrect; (2) a stuck fuel-level sensor may not be displayed in the instrument cluster; (3) the OBD system may cause the check engine light to illuminate incorrectly; and, (4) the speedometer may be out of tolerance.
Risk and remedy
- Risk
- In the event of a vehicle crash, the electrical fuel pump may not receive a crash signal that is required for the fuel pump to disconnect and prevent future fuel delivery as designed.
- Remedy
- Dealers will recode the scn free of charge. The recall began on august 30, 2008. Owners may contact mercedes-benz AT 1-800-367-6372.
- Filed by
- MERCEDES-BENZ USA, LLC. (manufacturer number 2008 070001)
On certain passenger vehicles equipped with diesel engines, the crankshaft sensor could fail due to separation of bond wires from the lead frame in the sensor. This results in an interruption in the electrical connection in the chip housing of the sensor.
Risk and remedy
- Risk
- When this happens, the vehicle may lose power rather than enter a limp-home mode. In addition, the vehicle cannot be restarted after failure of the electrical connection in the sensor, increasing the risk of a crash.
- Remedy
- Dealers will replace the crankshaft sensor. The recall began on february 4, 2008. Owners may contact mercedes-benz AT 1-800-367-6372.
- Filed by
- MERCEDES-BENZ USA, LLC. (manufacturer number 2008010005)
On certain vehicles, the accelerator pedal might not have been fully fastened to its mounting studs.
Risk and remedy
- Risk
- Over time, the pedal may not maintain a consistent pedal position, which could make it more difficult to operate the accelerator.
- Remedy
- Dealers will inspect and, if necessary, install the mounting nuts of the accelerator pedal. The recall began on january 16, 2007. Owners may contact mercedes-benz AT 1-800-367-6372.
- Filed by
- MERCEDES-BENZ USA, LLC. (manufacturer number 2006120008)