Owners have filed 445 complaints about the 2004 Nissan Quest with NHTSA, more than any other Quest model year on record.
The largest share concerns the electrical system (77 complaints, 17% of the total), followed by transmission and drivetrain (72) and engine (71). Half of those electrical reports describe a failure before 61,000 miles.
Complaints for this year mention 7 crashes, 10 fires, 39 injuries, and 4 deaths. These are owner reports and have not been verified by NHTSA.
NHTSA lists 4 recalls for this model year. The most recent, campaign 05V480000, was filed in October 2005 and concerns the mid/rear assembly.
EPA figures put it at up to 19 MPG combined (17 city, 24 highway) in its most efficient version, out of 2 configurations tested, close to the average minivan of its year.
On certain mini vans equipped with a folding third row rear seat, when the third row seat is raised from its stowed position, it engages striker brackets, one on each side of the seat cushion. The fold-away striker loop is welded to a mounting bracket. The striker may become detached from its mounting bracket due to a broken weld AT the point of attachment to the bracket.
Risk and remedy
- Risk
- If the third row seat striker weld fails, the striker could separate from the mounting bracket. Striker separation could affect the risk of injury in certain types of crashes.
- Remedy
- Dealers will replace the third row seat striker brackets free of charge. The recall began on december 19, 2005. Owners may contact nissan AT 1-800-647-7261.
- Filed by
- NISSAN NORTH AMERICA, INC.
05V474000
Filed Oct 13, 2005 109,437 vehicles
On certain mini vans, there is a seat adjustment mechanism that contains exposed moving components located AT the rear inside edge of the second row seat.
Risk and remedy
- Risk
- When the operator attempts seat adjustment, a finger may be pinched in the moving seat adjustment mechanism which could cause an injury.
- Remedy
- On earlier model vehicles built through june 28, 2004, dealers will replace the inboard second row seat adjustment handle, rivet a plastic reinforcement to backside of the existing seat back cover carpeting, install tie-downs and a flange to the inboard side shield. On vehicles produced from june 29, 2004 through september 26, 2005, dealers will rivet a plastic reinforcement to the backside of the existing seat back cover carpeting, install tie-downs and a flange on the inboard side shield. The recall began on december 19, 2005. Owners may contact nissan AT 1-800-647-7261.
- Filed by
- NISSAN NORTH AMERICA, INC. (manufacturer number R0504)
On certain minivans equipped with a power sliding door(s), AT an ambient temperature below approximately 40 degrees fahrenheit, the actuator for the power sliding door(s) may experience binding due to an out-of-specification condition. In order to open, close or reverse a power sliding door, the shift selector lever must be in "park." if the actuator is experiencing binding and the driver shifts the vehicle out of "park" while a power sliding door is still closing, the door latches may not engage.
Risk and remedy
- Risk
- This CAN result in the door coming open unexpectedly upon rapid acceleration, and an occupant could fall out of the door and be injured.
- Remedy
- Dealers will replace the actuator for the power sliding door(s). Owner notification began on june 23, 2004. Owners should contact nissan AT 1-800-647-7261.
- Filed by
- NISSAN NORTH AMERICA, INC. (manufacturer number RU401)