There are 6 safety recalls on file for the 1991 Chevrolet S-10,
filed between June 1990 and July 1999.
Each one is repaired free by a franchised Chevrolet dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1991 S-10 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1999 (1)
99V193000
Filed Jul 19, 1999 1,125,749 vehicles
Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.
Risk and remedy
- Risk
- If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
- Remedy
- Dealers will replace or repair the 4-wheel/2-wheel drive switch.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 99041)
1996 (1)
The intermediate steering shaft loosens AT the steering shaft to steering gear coupling. With this looseness, the yoke pinch bolt CAN wear on the splines of the shaft until there is no longer an interference between the splines and the bolt.
Risk and remedy
- Risk
- This condition CAN cause body to chassis movement allowing the steering shaft to separate from the steering gear which CAN result in a loss of steering control.
- Remedy
- Dealers will retorque the upper and lower bolts to correct specifications.
- Filed by
- GENERAL MOTORS CORP.
1993 (1)
93V008000
Filed Jan 14, 1993 215,052 vehicles
The engine cooling fan blades break as a result of fatigue and/or vehicle induced stress.
Risk and remedy
- Risk
- If the blade breakage occurs while the hood is open, aperson working under the hood or in the vicinity of the vehicle could be struckand injured by the blade segment.
- Remedy
- Install a newly designed fan assembly.
- Filed by
- GENERAL MOTORS CORP.
1991 (1)
91V108000
Filed Jun 21, 1991 102,885 vehicles
Vehicles have been shipped with the fuel tank sender seal out of position.
Risk and remedy
- Risk
- In the event of rollover accident, an out of postionseal could allow fuel spillage in excess of the amount prescribed by fmvss 301.spilled fuel could ignite near an ignition source.
- Remedy
- Replace sender seals.
- Filed by
- GENERAL MOTORS CORP.
1990 (2)
Nuts used to attach lower control arms, rear spring and shackle, and rear shock absorbers do not meet specifications and could "strip".
Risk and remedy
- Risk
- Stripping of the nuts in the rear suspension could reduceclamp load on lower control arm, which could allow the arm to detach, resultingin loss of vehicle control and an accident.
- Remedy
- Replace lower control arm attachment nuts as well as rear spring and shackle, and rear shock absorber nuts.
- Filed by
- GENERAL MOTORS CORP.
Use of improper primer on metal surfaces of windshield and side window openings could cause low adhesion to the metal surface and would not provide retention required by fmvss 212.
Risk and remedy
- Risk
- Windshield and side window glass would not prevent theejection of vehicle occupants during a vehicle crash, which causes seriousinjuries and fatalities.
- Remedy
- Remove and reinstall glass using proper primer.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1991 Chevrolet S-10 have?
NHTSA lists 6 recalls for the 1991 Chevrolet S-10.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.