Chevrolet · S-10

1994 Chevrolet S-10 Recalls

Small pickup · 4WD/AWD, RWD · Regular

There are 5 safety recalls on file for the 1994 Chevrolet S-10, filed between January 1994 and July 1999. Each one is repaired free by a franchised Chevrolet dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1994 S-10 is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1999 (1)

99V193000 Filed Jul 19, 1999 1,125,749 vehicles

Antilock/traction control/electronic limited slip

Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.

Risk and remedy
Risk
If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
Remedy
Dealers will replace or repair the 4-wheel/2-wheel drive switch.
Filed by
GENERAL MOTORS CORP. (manufacturer number 99041)

1997 (1)

97V096001 Filed Jun 12, 1997 586,058 vehicles

Seat belts

Vehicle description: extended cab pickup trucks equipped with 60/40 front bench seats and extended cab pickup trucks and 2-door utility vehicles equipped with manual locking recliner bucket seats. The outboard safety belt webbing on the driver's and/or passenger's seat CAN separate during a frontal impact.

Risk and remedy
Risk
If a separation occurred and there were secondary crash events or vehicle rollover, there would be no belt restraint of the occupant and increased injuries could occur.
Remedy
Dealers will install a protective cover over the recliner mechanism.
Filed by
GENERAL MOTORS CORP.

1996 (1)

96V195000 Filed Oct 8, 1996 144,598 vehicles

Shaft sector

The intermediate steering shaft loosens AT the steering shaft to steering gear coupling. With this looseness, the yoke pinch bolt CAN wear on the splines of the shaft until there is no longer an interference between the splines and the bolt.

Risk and remedy
Risk
This condition CAN cause body to chassis movement allowing the steering shaft to separate from the steering gear which CAN result in a loss of steering control.
Remedy
Dealers will retorque the upper and lower bolts to correct specifications.
Filed by
GENERAL MOTORS CORP.

1994 (2)

94V228000 Filed Nov 21, 1994 30,263 vehicles

Hoses, lines/piping, and fittings

A vacuum hose CAN detach from the power brake booster check valve as a result of engine backfire.

Risk and remedy
Risk
This CAN result in increased engine idle and loss of power brake assist after depletion of the booster vacuum reserve.
Remedy
Dealers will install a clamp on the power brake booster assist.
Filed by
GENERAL MOTORS CORP.
94V014000 Filed Jan 26, 1994 117,200 vehicles

Filler pipe and cap

The fuel tank filler pipes were not manufactured to specification which caused loss of fuel between the fuel tank filler pipe and the vent tube during a test. The loss of fuel was in excess of the amount permitted by fmvss no. 301, "fuel system integrity."

Risk and remedy
Risk
Consequence of non-compliance: if a vehicle crash were to occur, it may cause the joint between the fuel tank filler pipes and the vent tube to crack. If the vehicle overturned, fuel leakage would occur, which could result in a post-crash fire.
Remedy
Dealers will replace the fuel filler pipe on these vehicles.
Filed by
GENERAL MOTORS CORP.

Recall questions

How many recalls does the 1994 Chevrolet S-10 have?

NHTSA lists 5 recalls for the 1994 Chevrolet S-10.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.