There are 5 safety recalls on file for the 1995 Chevrolet S-10,
filed between September 1995 and July 1999.
Each one is repaired free by a franchised Chevrolet dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1995 S-10 is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1999 (1)
99V193000
Filed Jul 19, 1999 1,125,749 vehicles
Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.
Risk and remedy
- Risk
- If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
- Remedy
- Dealers will replace or repair the 4-wheel/2-wheel drive switch.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 99041)
1998 (1)
98V150001
Filed Jul 1, 1998 1,557,585 vehicles
Vehicle description: light duty pickup trucks and sport utility vehicles, 2 and 4-wheel drive. Solder joints near the wiring harness connector CAN crack causing the windshield wipers to work intermittently.
Risk and remedy
- Risk
- This condition CAN result in inoperative wipers, reducing a driver's visibility, and increasing the risk of a vehicle crash.
- Remedy
- Dealers will replace the wiper motor circuit board and cover.
- Filed by
- GENERAL MOTORS CORP. (manufacturer number 98043)
1997 (1)
97V096001
Filed Jun 12, 1997 586,058 vehicles
Vehicle description: extended cab pickup trucks equipped with 60/40 front bench seats and extended cab pickup trucks and 2-door utility vehicles equipped with manual locking recliner bucket seats. The outboard safety belt webbing on the driver's and/or passenger's seat CAN separate during a frontal impact.
Risk and remedy
- Risk
- If a separation occurred and there were secondary crash events or vehicle rollover, there would be no belt restraint of the occupant and increased injuries could occur.
- Remedy
- Dealers will install a protective cover over the recliner mechanism.
- Filed by
- GENERAL MOTORS CORP.
1996 (1)
The intermediate steering shaft loosens AT the steering shaft to steering gear coupling. With this looseness, the yoke pinch bolt CAN wear on the splines of the shaft until there is no longer an interference between the splines and the bolt.
Risk and remedy
- Risk
- This condition CAN cause body to chassis movement allowing the steering shaft to separate from the steering gear which CAN result in a loss of steering control.
- Remedy
- Dealers will retorque the upper and lower bolts to correct specifications.
- Filed by
- GENERAL MOTORS CORP.
1995 (1)
Fan blade rivet breakage CAN occur causing the fan blade to separate from the spider.
Risk and remedy
- Risk
- If this occurred while the hood was open, a person working under the hood of the vehicle or in the vicinity of the vehicle could be struck by the fan blade and injured.
- Remedy
- Dealers will inspect and replace, if necessary, the fan with a newer fan having thicker-headed rivets.
- Filed by
- GENERAL MOTORS CORP.
Recall questions
How many recalls does the 1995 Chevrolet S-10 have?
NHTSA lists 5 recalls for the 1995 Chevrolet S-10.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.