Chevrolet · S-10

1993 Chevrolet S-10 Recalls

Small pickup · 4WD/AWD, RWD · Regular

There are 3 safety recalls on file for the 1993 Chevrolet S-10, filed between June 1993 and July 1999. Each one is repaired free by a franchised Chevrolet dealer, no matter how old the car is or who owns it now.

A recall covers a range of build dates, so not every 1993 S-10 is affected by every campaign below. To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.

1999 (1)

99V193000 Filed Jul 19, 1999 1,125,749 vehicles

Antilock/traction control/electronic limited slip

Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive CAN malfunction causing increased stopping distances during ABS stops while in the two-wheel drive mode.

Risk and remedy
Risk
If this occurred AT a time when minimum stopping distance was required, a vehicle crash could occur without prior warning.
Remedy
Dealers will replace or repair the 4-wheel/2-wheel drive switch.
Filed by
GENERAL MOTORS CORP. (manufacturer number 99041)

1996 (1)

96V195000 Filed Oct 8, 1996 144,598 vehicles

Shaft sector

The intermediate steering shaft loosens AT the steering shaft to steering gear coupling. With this looseness, the yoke pinch bolt CAN wear on the splines of the shaft until there is no longer an interference between the splines and the bolt.

Risk and remedy
Risk
This condition CAN cause body to chassis movement allowing the steering shaft to separate from the steering gear which CAN result in a loss of steering control.
Remedy
Dealers will retorque the upper and lower bolts to correct specifications.
Filed by
GENERAL MOTORS CORP.

1993 (1)

93V105000 Filed Jun 21, 1993 409 vehicles

Anchorage

The outboard rear safety belt assembly will not release the webbing from the retracted position. This does not meet the requirements of fmvss 209, "seat belt assemblies."

Risk and remedy
Risk
If the outboard rear safety belt assembly will notrelease the webbing from the retracted position, safety belt use for the seatoccupant is impossible, increasing the risk of injury in an accident.
Remedy
Replace any belt that does not freely extend from the retracted position.
Filed by
GENERAL MOTORS CORP.

Recall questions

How many recalls does the 1993 Chevrolet S-10 have?

NHTSA lists 3 recalls for the 1993 Chevrolet S-10.

How do I know if my car's recall was fixed?

Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.