1991 Ford Crown Victoria Problems
Model year 1991
Owners have filed 55 complaints about the 1991 Ford Crown Victoria with NHTSA's vehicle safety hotline and website. The air bags leads with 11, then the electrical system with 10. Reports for this year mention 8 crashes, 5 fires, and 6 injuries.
One complaint can name more than one system, so the groups below add up to more than the total. Open a group for the parts owners name, the mileage and their own words.
- Air bags 20% of complaints · Frontal 11
- Electrical system 18% of complaints · Ignition 10
- Engine 13% of complaints · median 89,000 miles · Engine 7
- Speed control 13% of complaints · median 100,000 miles · Cruise Control 7
- Transmission and drivetrain 11% of complaints · median 89,000 miles · Automatic Transmission 6
- Tires 7% of complaints · median 2,000 miles · Tread/Belt 4
- Fuel system 7% of complaints · Delivery 4
- Body and structure 5% of complaints · Body 3
- Steering 5% of complaints · Hydraulic Power Assist System 3
- Other or unknown 4% of complaints 2
- Brakes 4% of complaints · Conventional 2
- Wheels 4% of complaints · Hub 2
- Equipment and accessories 4% of complaints · Appliance 2
- Seat belts 4% of complaints · Front 2
- Lights 2% of complaints · Turn Signal 1
- Suspension 2% of complaints · Front 1
Latest owner reports
Dt*: the contact stated while AT a stop, the gearshift was shifted into drive and the vehicle accelerated out of control, bounced over a high curb, and was fishtailing. The contact estimated the speed to have reached 70 MPH before the ignition was turned off. The vehicle was towed to the service dealer, who determined that the throttle pedal had seized. The manufacturer was notified. Updated 12/5/2006 -
When the vehicle was idling the consumer smelled a heavy scent of oil burning. While driving AT 65 MPH, the engine began revving AT a high rate. Also, the transmission gears would not go into third or fourth gear. The vehicle was taken to the dealer, who informed the consumer that the bushing was made of plastic. However, the bushing should be made from metal. The manufacturer had been informed. *ak when the cable linkage was disconnected, the destruction of the clutch would occur. (locking up the higher two gears, without the lock up only the first and second gear would work)
When the vehicle was idling the consumer smelled a heavy scent of oil burning. While driving AT 65 MPH, the engine began revving AT a high rate. Also, the transmission gears would not go into third or fourth gear. The vehicle was taken to the dealer, who informed the consumer that the bushing was made of plastic. However, the bushing should be made from metal. The manufacturer had been informed. *ak when the cable linkage was disconnected, the destruction of the clutch would occur. (locking up the higher two gears, without the lock up only the first and second gear would work)
Alternator plug shorted out and caused a high potentional overload that caught the alternator on fire. The short did not trip any fuse in vehicle. Fire was very intense. The fire quickly spread to adjacent component and melted plug wires, wire harnesses. Fire also damaged hood and right front fender. The fire was quickly spreading when help arrived to extinguish the fire. And yet no fuse ever tripped to engine electrical to stop short!