Ford · Crown Victoria

1990 Ford Crown Victoria

Model year 1990

Recalls 2 NHTSA campaigns Complaints 43 Most: electrical system
Fuel economy n/a No EPA rating
Crash rating pre-2011 NHTSA 5-Star program

Owners have filed 43 complaints about the 1990 Ford Crown Victoria with NHTSA, the 20th highest of 22 Crown Victoria years.

The largest share concerns the electrical system (10 complaints, 23% of the total), followed by air bags (7) and speed control (7).

Complaints for this year mention 7 crashes, 7 fires, and 4 injuries. These are owner reports and have not been verified by NHTSA.

NHTSA lists 2 recalls for this model year. The most recent, campaign 98V322000, was filed in December 1998 and concerns the lower ball joint.

What owners report

Full breakdown
98V322000 Filed Dec 16, 1998 175,000 vehicles

Lower ball joint

Vehicle description: certain 1996-1999 ford crown victoria police, fleet, natural gas, and 1996-1999 lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 ford crown victoria police, fleet, and ngv vehicles and 1990-1996 lincoln town car limousine vehicles that have been serviced with either a ball joint containing the one-piece bearing or a front lower control arm containing a ball joint with a one-piece bearing. The one-piece bearing within the lower control arm ball joint CAN weaken slowly during use and eventually crack. This could result in separation of the ball and cap of the joint, allowing the control arm to drop to the ground.

Risk and remedy
Risk
If this occurs while the vehicle is moving, reduced steering control could occur, increasing the risk of a crash.
Remedy
Dealers will replace the lower control arm ball joints (2).
Filed by
FORD MOTOR COMPANY (manufacturer number 98S37)
92V075000 Filed May 19, 1992 25,000 vehicles

Hoses, lines/piping, and fittings

The rear brake lines have inadequate clearance between the brake tube and the vehicle underbody in the area of the left rear wheel opening.

Risk and remedy
Risk
Inadequate clearance CAN cause abrasion of the brake lineand a leak CAN develop, resulting in loss of brake fluid to the rear brakesystem and increased stopping distances.
Remedy
Repair any brake lines that have an indication of contact or have the potential for contact with the body of the vehicle. Relocate lines, if necessary.
Filed by
FORD MOTOR COMPANY

Recent owner reports

Complaints as owners filed them with NHTSA, lightly tidied for readability. They are not verified.

Electrical system Filed Mar 2002 CT Fire

While driving a fire started near fuel pump assembly, causing vehicle to stop because power went out. Dealer had to replaced wiring harness and fuel pump sender assembly.

Owner complaint 8005183 filed with NHTSA
Fuel system Filed Mar 2002 CT Fire

While driving a fire started near fuel pump assembly, causing vehicle to stop because power went out. Dealer had to replaced wiring harness and fuel pump sender assembly.

Owner complaint 8005183 filed with NHTSA
Air bags Filed Sep 2001 PA

Airbag light blinks constantly. Consumer took vehicle to dealer, and they told consumer that this vehicle was not included in recall 90 e 043 001 due to VIN. Please provide any further information.

Owner complaint 895666 filed with NHTSA

How 1990 compares with other Crown Victoria years

Owner complaints per model year. The highlighted column is this year.

Questions about the 1990 Ford Crown Victoria

Does the 1990 Ford Crown Victoria have any recalls?

Yes. NHTSA lists 2 recalls for the 1990 Ford Crown Victoria, most recently 98V322000 (December 1998) for the lower ball joint.

What are the most common problems with the 1990 Ford Crown Victoria?

Owner complaints to NHTSA most often involve the electrical system (10), air bags (7), and speed control (7).