There are 3 safety recalls on file for the 1991 Ford Crown Victoria,
filed between March 1991 and December 1998.
Each one is repaired free by a franchised Ford dealer, no matter how old the car is or who owns it now.
A recall covers a range of build dates, so not every 1991 Crown Victoria is affected by every campaign below.
To see which ones apply to your car and whether they were already done, enter its VIN at nhtsa.gov/recalls.
1998 (1)
98V322000
Filed Dec 16, 1998 175,000 vehicles
Vehicle description: certain 1996-1999 ford crown victoria police, fleet, natural gas, and 1996-1999 lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 ford crown victoria police, fleet, and ngv vehicles and 1990-1996 lincoln town car limousine vehicles that have been serviced with either a ball joint containing the one-piece bearing or a front lower control arm containing a ball joint with a one-piece bearing. The one-piece bearing within the lower control arm ball joint CAN weaken slowly during use and eventually crack. This could result in separation of the ball and cap of the joint, allowing the control arm to drop to the ground.
Risk and remedy
- Risk
- If this occurs while the vehicle is moving, reduced steering control could occur, increasing the risk of a crash.
- Remedy
- Dealers will replace the lower control arm ball joints (2).
- Filed by
- FORD MOTOR COMPANY (manufacturer number 98S37)
1992 (1)
The rear brake lines have inadequate clearance between the brake tube and the vehicle underbody in the area of the left rear wheel opening.
Risk and remedy
- Risk
- Inadequate clearance CAN cause abrasion of the brake lineand a leak CAN develop, resulting in loss of brake fluid to the rear brakesystem and increased stopping distances.
- Remedy
- Repair any brake lines that have an indication of contact or have the potential for contact with the body of the vehicle. Relocate lines, if necessary.
- Filed by
- FORD MOTOR COMPANY
1991 (1)
The park rod assembly contains a park cam with inadequate surface hardness, which could lead to park disengagement or no park engagement when the lever is placed in park.
Risk and remedy
- Risk
- If park is not engaged and the parking brake is off, avehicle roll-away could result.
- Remedy
- Replace park rod assembly on automatic transmissions.
- Filed by
- FORD MOTOR COMPANY
Recall questions
How many recalls does the 1991 Ford Crown Victoria have?
NHTSA lists 3 recalls for the 1991 Ford Crown Victoria.
How do I know if my car's recall was fixed?
Enter your 17-character VIN at nhtsa.gov/recalls or on the manufacturer's site. It shows any recall that has not been repaired on that specific vehicle.