Owners of the 1995 Ford Crown Victoria have reported 5 seat belt problems to NHTSA, 2% of all complaints about this model year.
Where owners named a specific part, the most common were front (5).
The typical report came at around 20,000 miles, and complaints were filed between August 1995 and August 2003.
These seat belt complaints include 1 crash and 1 injury.
For comparison, the 2005 Crown Victoria has the most seat belt complaints of any year, with 7.
Belts, buckles, retractors, pretensioners and anchorages.
1 recall for this model year involves the seat belt.
If your problem matches, a dealer repairs it free under the recall.
Complaints5
Typical mileage20k
Crashes / fires1 / 0
Injuries1
Parts named in these complaints
Front5
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
Seat beltsFiled Aug 200320,000 milesMO
Driver side seat belt is inoperative. Belt will either, not fasten or will release while fastened. Cause of the failure is undetermined. Also hile driving and brake pedal depressed, the pedal will "surge against driver's feet". When this occurs vehicle fails to stop, causing extended stopping distance.
The rivets holding the rear outboard belt d-rings were not heat treated properly causing the heads of the rivets to fracture under load and fail to hold the d-rings to the straps. This does not conform to the requirements of fmvss no. 210, "seat belt assembly anchorages."
Risk and remedy
Risk
Consequence of non-compliance: this condition CAN reduce the restraining capabilities of the safety belt in the event of an accident.
Remedy
Dealers will install a reinforcement plate on the rear outboard seat belt assembly anchorages involved in this campaign.