Owners of the 1995 Ford Crown Victoria have reported 35 suspension problems to NHTSA, 14% of all complaints about this model year.
Where owners named a specific part, the most common were front (33).
The typical report came at around 94,000 miles, and complaints were filed between October 1995 and July 2013.
These suspension complaints include 2 crashes and 1 injury.
For comparison, the 1996 Crown Victoria has the most suspension complaints of any year, with 51.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
1 recall for this model year involves the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints35
Typical mileage94k
Crashes / fires2 / 0
Injuries1
Parts named in these complaints
Front33
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled Jul 2013192,000 milesOH
Tl* the contact owns a 1995 Ford Crown Victoria. The contact stated that while exiting a residential drive way, the driver's side front suspension ball joint fractured and separated from the vehicle. The manufacturer advised the contact that the vehicle was not included in NHTSA campaign ID number: 98v322000 (suspension). The vehicle was not repaired. The failure and current mileage was 192,000.
Owner complaint 10524308 filed with NHTSA
SuspensionFiled Nov 201193,000 milesFL
Tl* the contact owns a 1995 Ford Crown Victoria. The contact stated that while driving approximately 5 MPH, the driver side front fell to the ground and the tire buckled inward. The vehicle was towed to an independent mechanic where they advised him that the ball joint had come out from the socket and needed to be replaced. The vehicle was repaired. The manufacturer was contacted and they offered no assistance. The failure mileage was approximately 93,000.
Owner complaint 10437698 filed with NHTSA
SuspensionFiled Apr 201183,000 milesAL
I have a 1995 Ford Crown Victoria with 83,000 miles on it. The control arm dropped and hit the road, causing loss of steering. Lucky for US we were going slow turning into a place of business, if we were going fast it could have been bad news. This car started a squeak on the front a little while ago, I guess it had something to do with it. I have noticed alot of 90's and some 2000's model fords have this same squeak. I contacted Ford, and they said there was no recall on my model, I told them there should be.
Vehicle description: certain 1996-1999 ford crown victoria police, fleet, natural gas, and 1996-1999 lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 ford crown victoria police, fleet, and ngv vehicles and 1990-1996 lincoln town car limousine vehicles that have been serviced with either a ball joint containing the one-piece bearing or a front lower control arm containing a ball joint with a one-piece bearing. The one-piece bearing within the lower control arm ball joint CAN weaken slowly during use and eventually crack. This could result in separation of the ball and cap of the joint, allowing the control arm to drop to the ground.
Risk and remedy
Risk
If this occurs while the vehicle is moving, reduced steering control could occur, increasing the risk of a crash.
Remedy
Dealers will replace the lower control arm ball joints (2).