Mazda · MAZDASPEED3

2007 Mazda MAZDASPEED3

Model year 2007

Recalls 2 NHTSA campaigns Complaints 38 Most: transmission and drivetrain
Fuel economy n/a No EPA rating
Crash rating pre-2011 NHTSA 5-Star program

Owners have filed 38 complaints about the 2007 Mazda MAZDASPEED3 with NHTSA, more than any other MAZDASPEED3 model year on record.

The largest share concerns the transmission and drivetrain (17 complaints, 45% of the total), followed by engine (15) and tires (4). Half of those transmission reports describe a failure before 12,000 miles.

Complaints for this year mention 1 crash. These are owner reports and have not been verified by NHTSA.

NHTSA lists 2 recalls for this model year. The most recent, campaign 07V295000, was filed in July 2007 and concerns the engine and engine cooling.

What owners report

Full breakdown
  • Transmission and drivetrain 45% · typically 12,000 miles 17
  • Engine 39% · typically 12,000 miles 15
  • Tires 11% · typically 12,000 miles · 1 crash 4
  • Suspension 11% · typically 12,000 miles 4
  • Body and structure 8% · typically 4,000 miles 3
  • Other or unknown 3% 1
  • Brakes 3% · typically 30,000 miles 1
  • Lights 3% · typically 63,000 miles 1
07V295000 Filed Jul 10, 2007 5,700 vehicles

Engine and engine cooling

On certain passenger vehicles, the no. 4 left side engine mount bolt may loosen if a sudden rapid acceleration is repeatedly performed.

Risk and remedy
Risk
If the vehicle is continuously driven under such condition, the no. 4 engine mount bolt may loosen and pull out or break, allowing the transmission to be out of position. In extreme cases, the drive shaft may become detached. If this occurs the vehicle will lose power and will come to a stop, increasing the risk of a crash.
Remedy
Dealers will inspect and replace the no. 4 engine mount bolt with a modified one, and, if necessary, replace the no. 4 engine mount rubber and bracket with new ones free of charge. The recallbegan on july 13, 2007. Owners may contact mazda AT 800-222-5500 .
Filed by
MAZDA MOTOR CORP (manufacturer number 4607F)
07V052000 Filed Feb 15, 2007 1,700 vehicles

Equipment

On certain passenger vehicles equipped with optional accessory all weather floor mats, there is insufficient clearance between the floor mat and accelerator pedal.

Risk and remedy
Risk
In this situation it is possible that the accelerator pedal might get stuck behind the floor mat, which may prevent the vehicle from properly decelerating when the accelerator is released increasing the risk of a crash.
Remedy
Owners will be instructed to return the floor mats to dealers and will be shipped a new floor mat free of charge. The recall began on march 7, 2007. Owners may contact mazda AT 1-800-222-5500.
Filed by
MAZDA MOTOR CORP (manufacturer number 4407B)

Recent owner reports

Complaints as owners filed them with NHTSA, lightly tidied for readability. They are not verified.

Transmission and drivetrain Filed Aug 2014 74,200 miles MI

On Saturday 19 July 2014, my wife and I were driving north on highway 131, 18 miles south of grand rapids, mi when without notice the engine's number 1 cylinder blow a hole through the casting and damaging the inner axle shaft carrier bearing. When the engine blew, it caused the car to shake violently causing me, the driver, to lose control of the vehicle. I was able to regain control of the vehicle before the car swerved into an adjacent lane. Prior to the incident the vehicle was in good running condition and had just passed the virginia state inspection a few months prior.

Owner complaint 10625871 filed with NHTSA
Engine Filed Aug 2014 74,200 miles MI

On Saturday 19 July 2014, my wife and I were driving north on highway 131, 18 miles south of grand rapids, mi when without notice the engine's number 1 cylinder blow a hole through the casting and damaging the inner axle shaft carrier bearing. When the engine blew, it caused the car to shake violently causing me, the driver, to lose control of the vehicle. I was able to regain control of the vehicle before the car swerved into an adjacent lane. Prior to the incident the vehicle was in good running condition and had just passed the virginia state inspection a few months prior.

Owner complaint 10625871 filed with NHTSA
Transmission and drivetrain Filed Aug 2014 74,200 miles MI

On Saturday 19 July 2014, my wife and I were driving north on highway 131, 18 miles south of grand rapids, mi when without notice the engine's number 1 cylinder blow a hole through the casting and damaging the inner axle shaft carrier bearing. When the engine blew, it caused the car to shake violently causing me, the driver, to lose control of the vehicle. I was able to regain control of the vehicle before the car swerved into an adjacent lane. Prior to the incident the vehicle was in good running condition and had just passed the virginia state inspection a few months prior.

Owner complaint 10621872 filed with NHTSA

How 2007 compares with other MAZDASPEED3 years

Owner complaints per model year. The highlighted column is this year.

Questions about the 2007 Mazda MAZDASPEED3

Does the 2007 Mazda MAZDASPEED3 have any recalls?

Yes. NHTSA lists 2 recalls for the 2007 Mazda MAZDASPEED3, most recently 07V295000 (July 2007) for the engine and engine cooling.

What are the most common problems with the 2007 Mazda MAZDASPEED3?

Owner complaints to NHTSA most often involve the transmission and drivetrain (17), engine (15), and tires (4).