Ford · Crown Victoria

1993 Ford Crown Victoria Suspension Problems

Large car · RWD · Regular

Owners of the 1993 Ford Crown Victoria have reported 11 suspension problems to NHTSA, 6% of all complaints about this model year.

Where owners named a specific part, the most common were front (9) and rear (1).

The typical report came at around 155,000 miles, and complaints were filed between July 1997 and February 2014.

For comparison, the 1996 Crown Victoria has the most suspension complaints of any year, with 51.

Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.

2 recalls for this model year involve the suspension. If your problem matches, a dealer repairs it free under the recall.
Complaints11
Typical mileage155k
Crashes / fires0 / 0
Injuries0

Parts named in these complaints

  • Front9
  • Rear1

Owners choose these labels when they file, so they are a guide rather than a diagnosis.

What owners say

Suspension Filed Sep 2010 140,000 miles FL

Tl* the contact owns 1993 Ford Crown Victoria. The contact stated while driving 70 MPH the front driver's side ball joint broke, causing the lower control arm to collaps. The driver's side upper control arm was also damaged as well, causing the contact to lose control of the steering ,which almost caused a crash. The contact had the vehicle towed to his residence. The contact repaired the front passenger side control arm. He referenced the recall for the suspension:front:control arm:upper arm (95v194000) however, his VIN was not included in the recall.

Owner complaint 10355766 filed with NHTSA
Suspension Filed Feb 2008 172,000 miles TX

Tl*the contact owns a 1993 Ford Crown Victoria. While driving AT an unknown speed, the contact noticed that the vehicle sporadically veered to the right. The dealer stated that although he was experiencing the same failure as noted in NHTSA campaign ID number 95v194000 (suspension:front:control arm:upper arm), the VIN was not included in the recall and they would not repair his vehicle for free. The vehicle is currently being repaired. The failure mileage was 172,000 and current mileage was 173,000.

Owner complaint 10219595 filed with NHTSA

Related recalls

98V322000 Filed Dec 16, 1998 175,000 vehicles

Lower ball joint

Vehicle description: certain 1996-1999 ford crown victoria police, fleet, natural gas, and 1996-1999 lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 ford crown victoria police, fleet, and ngv vehicles and 1990-1996 lincoln town car limousine vehicles that have been serviced with either a ball joint containing the one-piece bearing or a front lower control arm containing a ball joint with a one-piece bearing. The one-piece bearing within the lower control arm ball joint CAN weaken slowly during use and eventually crack. This could result in separation of the ball and cap of the joint, allowing the control arm to drop to the ground.

Risk and remedy
Risk
If this occurs while the vehicle is moving, reduced steering control could occur, increasing the risk of a crash.
Remedy
Dealers will replace the lower control arm ball joints (2).
Filed by
FORD MOTOR COMPANY (manufacturer number 98S37)
95V194000 Filed Oct 11, 1995 57,000 vehicles

Upper arm

The bolts that attach the front upper control arms to the frame mounting brackets CAN loosen and fracture AT one of the bolt holes causing substantial negative camber and steering pull to the affected side.

Risk and remedy
Risk
If the driver's side bracket fractured AT both bolt holes, the steering control arm CAN contact the steering column shaft and result in a loss of steering control increasing the potential for an accident.
Remedy
Dealers will inspect the torque levels of the four upper control arm mounting bolts, and if any are loose, the brackets will be inspected for damage. If damage is present, it will be repaired.
Filed by
FORD MOTOR COMPANY

Suspension complaints across Crown Victoria years

Questions about suspension problems

How common are suspension problems on the 1993 Ford Crown Victoria?

11 owners have reported suspension problems to NHTSA, 6% of all complaints for this model year.

Is there a recall for suspension problems on the 1993 Ford Crown Victoria?

Yes. 2 recalls for this model year concern the suspension: 98V322000, 95V194000.