Owners of the 1996 Ford Crown Victoria have reported 51 suspension problems to NHTSA, 18% of all complaints about this model year.
Where owners named a specific part, the most common were front (50).
The typical report came at around 131,000 miles, and complaints were filed between May 1996 and August 2017.
No other Crown Victoria year has as many suspension complaints.
Springs, struts, shocks, control arms, ball joints, bushings and stabilizer links, front and rear.
1 recall for this model year involves the suspension.
If your problem matches, a dealer repairs it free under the recall.
Complaints51
Typical mileage131k
Crashes / fires0 / 0
Injuries0
Parts named in these complaints
Front50
Owners choose these labels when they file, so they are a guide rather than a diagnosis.
What owners say
SuspensionFiled Aug 2017136,000 milesOH
Tl* the contact owns a 1996 Ford Crown Victoria. The contact stated that while making a left turn off a driveway onto a lot, there was a loud metal braking noise coming from the front driver side of the vehicle. The contact stated that the front driver side collapsed to the ground. The contact noticed the lower ball joint detached. The vehicle was towed to a private independent parking lot where the contact was to inspect the vehicle. The vehicle was not taken to a dealer. The vehicle was diagnosed or repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 136,000.
Owner complaint 11012424 filed with NHTSA
SuspensionFiled Jun 2011125,000 milesIL
Tl*the contact owns a 1996 Ford Crown Victoria. The contact stated while driving AT a low speed the front drivers side lower control arm broke. The contact did not talk to the manufacturer regarding the lower control arm. The contact stated the vehicle was unsafe to drive. The failure mileage was 125,000.
Owner complaint 10407258 filed with NHTSA
SuspensionFiled Aug 2006280,000 milesWA
Dt*: the contact stated the lower control arm ball joint fractured while driving 20 MPH on a dry highway. There was a NHTSA recall, # 98v322000, regarding the suspension: front: control arm: lower ball joint. The vehicle was not included in the recall due to the VIN.
Vehicle description: certain 1996-1999 ford crown victoria police, fleet, natural gas, and 1996-1999 lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 ford crown victoria police, fleet, and ngv vehicles and 1990-1996 lincoln town car limousine vehicles that have been serviced with either a ball joint containing the one-piece bearing or a front lower control arm containing a ball joint with a one-piece bearing. The one-piece bearing within the lower control arm ball joint CAN weaken slowly during use and eventually crack. This could result in separation of the ball and cap of the joint, allowing the control arm to drop to the ground.
Risk and remedy
Risk
If this occurs while the vehicle is moving, reduced steering control could occur, increasing the risk of a crash.
Remedy
Dealers will replace the lower control arm ball joints (2).